USE, CARE, AND INSTALLTION GUIDE Please read all manual carefully before installing and operating this appliance.
CONTENTS 1. Product introduction 2. Installation 3. Technical parameters 4. Switch operation 5. Maintenance 6.
1. Product introduction Thank you very much for choosing our range hood. Our company has developed a series of range hoods on the basis of assimilating the advantages of high volume of air, lower noise and elegant appearance.
2. Installation and Operation Wall mounted：1.Drill two holes on the wall 2.Two iron expansion fixed on the wall Under cabinet: 1.Drill 4 holes on the ceiling 2.Four iron expansion fixed on the ceiling 1) Position the range hood on the center of cooking stove wall. For best results, the mounting height of the range hood should be 65-75cm (25"-30") above the top of the range. Mark the position of the holes, which need to be drilled in order to mount the range hood.
2) According to marks, drill two holes appropriate for heavy duty wall anchors and screws（not included）. Mount the range hood on the wall with the two screws and anchors and tighten. 3) Install the one-way valve on top of the range hood and assemble the exhaust pipe and decorative cover. 4) Affix the decorative cover with two M4 tapping screws on the hood body. 5) Make sure all switches are off and then insert the electrical plug into an outlet. 3.
4.Switch operation ① ② ③ ④ ⑤ ①：Turn off ②：Low speed setting ③：Medium speed setting ④：High speed setting ⑤：Turn on/off the lamp 5. Maintenance 1) Make sure to pull out the plug and cut off the power before maintenance to ensure your safety. 2) Clean the inside and outside of the range hood with warm water containing neutral detergent, then dry them with a piece of dry cloth. Do not scrub them with rough materials such as cleansing ball to avoid damages to the surface.
month to a month. 3) Do not crush the wind wheel when cleaning the inside of the wind track of the wind wheel to avoid the deformation of the wind wheel. Otherwise the movement will be increased, which will result in more noise and influence the effect of absorbing the oil-smoke. 4) Frequent cleaning of the filter shall be done.
6) Cut off all the circuits with power before approaching the connection ends. 7)This appliance is not intended for use by young children and infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely。 8) Young children should be supervised to ensure that they do not play with the 9) There should be adequate ventilation of the room when the range hood is used at the same time as appliance burning gas or other fuels.
FCC Requirement changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
