Specification

High Temperature Red Acetoxy Sealant
Technical Data Sheet
HI-TEMP SILICONE
D I V ERS I F I ED P R O DUC T S
Recommendations for use of this product are based on tests we believe to be reliable. Manufacturer and seller are not
responsible for results where this product is used under conditions beyond our control. If when applied as directed,
this material peels, cracks or separates, it will be replaced without charge upon presentation of proof of purchase
and used cartridge. This limited warranty only applies to residential use and damages including consequential
damage and other remedies are excluded. No other warranties apply, including tness for a particular purpose.
Caution:
Use only with adequate ventilation. Avoid contact
with eyes and skin. Wash hands after using. Do not
transfer contents to other containers for storage.
2/2
EverKem Diversied Products
5180 Indiana Avenue Winston Salem, 27106
PH: 1.800.638.3160 / FX: 1.336.661.7969
www.everkemproducts.com
1. Clean debris and dry desired area.
2. Cut tip off cartridge. Screw nozzle on end and cut tip to desired bead size. Insert cartridge into standard caulk
gun.
3. Hold at 45° angle and apply by pushing sealant ahead of nozzle to achieve a smooth seal. Apply using a
steady, even pressure to completely bridge joints.
4. Complete tooling within 5 minutes. Use dry paper towler to remove excess material. Smooth caulk using wet
nger or a damp cloth for a clean, neat appearance.
5. Sealant normally “skins over” in 5 minutes, dries to touch in 1 hour,and cures & bonds in 24 hours. Allow 7 day
cure time to reach maximum strength.
Application Limitations:
▪ Structural silicone glazing
▪ Joints where physical abuse or abrasion is likely to be encountered
▪ Prolonged water immersion
▪ Porous surfaces, such as masonry
▪ Building materials that might bleed oils, plasticizers, or solvents - materials such as impregnated wood, oil-
based caulks, green or partially vulcanized rubber gaskets or tapes.
▪ Totally conned spaces, as sealant requires atmospheric moisture for cure.
▪ Surfaces that will be painted, as paint will not stretch with extensions of the sealant and may crack & peel
Application Procedures:
Disclaimer:
KEEP OUT OF REACH OF CHILDREN
Part # Product Description Color Case Quantity
HTS-100 Hi-Temp Silicone Red 103. Fl. Oz. Tube Red 12 tubes/case
Packaging Options:
Excess caulk should be cleaned off tools and nonporous surfaces while it is in the uncured state using
mineral spirits and a dry cloth or paper towels. Cured compound should be cut away.
Clean Up Procedures:
Scan this QR Code to be directed to our online product page,
where you can view additional information including Safety
Data Sheets and Applicable Testing Documentation