User manual

56
5.8.3 Call M/T Seq.
Use this menu page to configure the dwell times (the
number of seconds a specific channel will be displayed)
and the order in which the camera channels will be
displayed on the Call Monitor.
The configured sequence will repeat continuously from
steps 1 through 20 until interrupted.
Step: This number shows the position of the related
camera in the sequence – for reference.
Camera: Select which camera will appear in this
position/step.
Dwell (sec): Set the dwell time for each step/camera (from 0 to 99 seconds).
The configured sequence will repeat continuously from steps 1 through 20 until interrupted.
5.9 SYSTEM SETTING
On the right is a screenshot of the SYSTEM SETTING MENU. This menu is for setting up the general system parameters
for the DVR.
5.9.1 Date/Time
Date: Set current Date.
Time: Set current Time.
Date Format: Choose date format from yyyy/mm/dd,
dd/mm/yyyy, and mm/dd/yyyy.
Time Format: Change time format between 12H and 24H
mode.
Time Zone: Set the time zone that the DVR adjusts to
when updating from the time server.
NTP: Select “Enable” or “Disable” NTP time synchronization.
NTP Server: Displays the time server address that the DVR uses for time synchronization. Requires operating network
configuration and WAN or LAN access to a compatible NTP server.
To find a compatible NTP address, please follow these steps:
a) Go to a PC that is connected to the internet.
b) Click on “START” -> “RUN” -> type “command” and press “OK”.
c) In the DOS Prompt, type “ping pool.ntp.org” to find out the IP address of an NTP Server.
NTP Update Interval: The frequency that the system automatically updates the time via the NTP server. Select Daily,
Weekly, or Monthly.