User manual

Power Loss:

Log: This box should be permanently checked to log all

Power Loss incidents.

Email Notify: Check this box to enable email notification

of this event when power has been restored. This

requires that valid email settings have been entered in

the Network Setting > Email setup screen.

Network Alarm: Check this box to send out a network

alarm to a client PC when power has been restored.

(This feature requires PowerCon software on the client

PC and proper settings for the Alarm Server in the Network Setup menu; see the Alarm Server section for more information.)

NOTE: As alarms and emails cannot be transmitted without power, the log entry is made when power is restored, and the

same applies to all event notifications.

Network Loss:

Log: Check this box to record Network Loss events in the

log.

Buzzer: Check this box to activate the buzzer when the

network connection is lost.

Alarm Output: Click on one of the numbers in the

dropdown box to let the DVR transmit a signal through the

alarm output with the same number, if this event occurs.

Selecting “None” would disable this reaction.

Output Type: If an Alarm Output has been selected

above this setting, this setting will decide how that Output

is transmitted when this event occurs.

Timeout: The alarm output will last for a set period of

time. If this option is selected, a field will appear under this field for setting the period duration. Setting options are

1~150 seconds.

Permanent: The alarm will remain on until the user presses the “Enter” key on the front panel, or resets the alarm

configuration.

Transparent: The alarm output will continue for as long as the event trigger is detected.

Trans+Timeout: The alarm output will continue as long as the event trigger is detected, then it will continue for the set

time period.

Timeout Duration: This period refers to the Timeout output type above and can be from 1 to 150 seconds.

NOTE:

This function only checks the physical connection (link) to the network. Any network behavior that blocks data

connectivity (blocked ports, IP addressing errors, etc.) is not detected by this function.