User`s manual

NVR8004X
9
2.2 Basic Connection
The instructions below describe the connection for the NVR8004X.
Front View
Rear View
Internal HDDs (Optional)
Power Supply
USB3.0 USB2.0
Network
Web Remote
Client
PowerVideo Plus
(CMS)
Dongle / Mouse /
USB Memory Stick
Hub
IP Camera
1
2
3
4
5
Figure 2-8
1. Install 1 to 4 HDDs (Please refer to 2.1 Hard Disk Installation).
2. Connect a Dongle to the NVR and optionally connect a Mouse and USB Memory Stick to
the NVR.
3. To manage the NVR over network, connect the supplied standard RJ-45 cable from your
network to LAN2 (Static IP) port. Please see 4.5.1 LAN for more details.
4. To connect IP cameras, please use a hub to connect between NVR and IP cameras. It’s
recommended to connect the hub to the LAN1 (DHCP) of the NVR. Please see 4.5.1 LAN
for more details.
5. Using the supplied Power Cord, connect one end to the 19 VDC port on the NVR and the
other end to the power outlet.
Note: Before powering on the NVR, please connect the USB Dongle and install the HDDs first.
Please see 2.3 USB Dongle Connection and 2.4 Turning On / Off the Power for more details.