User`s manual

NVR8004X
4
1.5 Front Panel
1
2
3
4
Figure 1-2
Note: For example, if the HDD1 is installed before turning on the NVR, the HDD1 LED indicators
will emit light once the NVR is powered on. Then, if you hot-swap either one of HDD1~4, still
only the HDD1 LED indictor remains light up. You can reboot the NVR manually and the HDD
LED indication will be corrected.
No. Name Description
1 Status LED
SYS: Indicates the system is working.
EXT: Indicates the NVR is connected to the external storage device or
USB dongle.
LAN1 / LAN2: Indicates the NVR is connected to the network.
HDD1~4: Indicates the internal HDD is activating, but the LED
indicators will light up only if you install the HDDs before turning on
the NVR. If the NVR is already on and you hot-swap the HDDs, the
HDD1~4 LED indicators will still remain on / off as the previous status,
please see the example in the note below.
PWR: Indicates the power is on.
2 Power Press to turn on / off the NVR.
3 HDD Tray Pull the HDD tray out to install the HDD.
4 Lock Use the supplied key to lock / unlock the NVR.