User manual

NVR/DVR/Hybrid NDVR System

- 67 -

4.2.4 Action Type - Send E-mail

The system will send an E-mail immediately to given accounts indicating the type of event, the

time, and attaching a picture taken while the event is

detected.

Step 1: Select the “Send E-mail” action and then click OK.

Step 2: The responding window will popup to Select Contact, type the message to append. (You can

choose more than one contact).

Edit Address Book: Insert the contact information here.

Note:

1. To give the system the E-mail accounts, go to Config > Setup > Hotline. See Configurations on

page 81 for details.

2. For Digital Input Events, this warning action will send the snapshot of the associated camera.

Please refer to I/O settings for details.

4.2.5 Action Type - Phone Call

The system will call a given phone number when an unusual event is detected.

* Note: This function is not available under Lite License.

Step 1: Select the Phone Call action and then click OK.

Step 2: The responding window will popup to Select Contactor and key-in the message which want to

append on SMS content. (You can choose one more contact at once).

Note: To setup the phone number and make an audio record for the phone call, go to Config - Setup

- Hotline. See Configuration on page 81l.

4.2.6 Action Type - PTZ Preset Go

The PTZ (pan/tilt/zoom) camera will go to a preset point or auto patrol when an unusual event is

detected.

* Note: This function is not available under Lite license.

Step 1: Select the “PTZ Preset Go” action and then click OK.

Step 2: The responding window will pop up to PTZ Camera Preset Go. Click the “PTZ Preset Go” indicator to

modify the setting.

Step 3: Set the action of cameras which you want to trigger by events.

For example: Please follow below steps to setup this function.

 Set the action of camera 1:

1. Choose camera 1.

2. Set the start, end preset points.

3. Select the Life Cycle.

4. Click on Add.

 Set the action of camera 2:

5. Choose camera 2.

6. Set the start patrol and end patrol.

7. Select the Life cycle

8. Click on Add.

9. Finally click on Ok to save all setting of cameras.

Note: Configure your PTZ camera before using this function. See Config on page 78 for PTZ camera

configuration.

4.2.7 Action Type – DI/DO

To trigger Digital input/output devices connected to the system, such as alarm lights and sirens.