DVR User Manual
Table Of Contents
- 1 PRODUCT OVERVIEW
- 2 Installation
- 3 MOUSE AND FRONT PANEL OPERATION
- 3. GENERAL DVR OPERATIONS
- 4 DVR CONFIGURATION
- 5 Networking Overview
- 6 REMOTE OPERATION FROM BROWSER
- 7 EVERFOCUS DDNS SETUP
- 8 LINKSYS & D-LINK PORT FORWARDING
- 9 TROUBLESHOOTING
- APPENDIX A: TIMING OF ALARM MODES
- APPENDIX B: EXPRESS SETUP RECORDING VALUE SELECTION RULES
- APPENDIX C: REMOTE CONTROL
60
HD Off:
Figure 4-16 Alarm & Event Menu – Event - HD Off
Buzzer: Check box to enable buzzer if the hard drive is turned off (disconnected) or becomes disabled
(cannot be detected by the system).
Email Notify: Check box to enable email notification when HD is off. Email operation requires that valid
email settings have been entered in the Network Setting/Email setup screen.
Network Alarm: Check box to send out a network alarm to client PC. (requires PowerCon software and
setting up Alarm Server in Network Setup menu)
Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either “NONE” (not
active), “1” or “2”(active).
Output Type: Output action when alarm is triggered.
Timeout:
Alarm output lasts for the set time duration.
Permanent:
Alarm will be continuously active until user presses “Enter” key.
Transparent:
Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: The amount of time the buzzer sounds when the HD is off. Duration selectable from 1
to 150 seconds.