User`s manual

PoE Switch
43
Figure 9-2

Member: This column allows you to select the member Ports.

Status: This column allows you to Enable/Disable the Trunk Group.

Type: This column allows you to choose Static Trunking or Dynamic LACP
Trunking.
After Select the LACP Trunk type, the following parameters can be configured. Please
noted that the parameters of the both ends of the LACP should be the same.

Operation Key: This column allows you to type operation key.

Time Out: This column allows you to select Long Time Out Time or Short Time
Out Time. The Long Time Out is around 30 seconds, the Short Time Out is around
3 seconds, however, the link partner of other supplier may not use the same
value. The longer time then will be used.

Activity: This column allows you to select Passive or Active mode.
Note: If you enable LACP on some specified ports and their link partners are normal
port without LACP, these specified ports cannot transmit packet to/receive packet
from the link partner.