User`s manual

EPN4122/4122i/4220/4220i
75
4. To set up the Left / Right positions for the area, use the direction buttons to move to a desired
position and then click the Set button. Optionally use the Zoom / Focus / Iris buttons if necessary.
You can select a pan and tilt speed from the PT Speed drop-down list for the camera to move to the
directions when you use the direction buttons during the configuration period.
After you click the Set buttons for the Set Left / Right Pos, a Range data will be displayed as in the
image above, indicating the horizontal segment, in degrees, of the zone you just configured. 0° is
the north point, which can be left on the default value, or which can be set by you in the
Directions North field below.
5. Follow Step 2 to 4 to set up another Zone.
6. Click Apply to apply the settings.
After the above settings, select Zones in the OSD Display Settings field and you can see the Zone Titles
displayed on the camera view when you navigate the camera to the configured zones.
【Directions North】You can configure the North position on the camera view. Follow the steps below:
1. Use the direction controls to move your camera so that it points in the direction that you want to
set as the camera’s North position (0° on the horizontal axis).
2. Click the Set button to turn that horizontal direction into the camera’s North.
3. Click the Default button if you want to reset to the camera’s default North position.
【OSD Display Settings】Select ON / OFF to enable / disable displaying the following selected items on
the camera view.
Directions: Checking this box will display the horizontal and vertical direction values of the camera. The
display will show the horizontal pointing position in degrees (360°) in relation to the North Point (0° -
either the default North or as set by the user) on the left of the directions display, and on the right it
will show the vertical pointing position in degrees (90°) in relation to the ground.
Zones: Checking this box will display the preconfigured horizontal zones that the camera is currently
pointing in.
Zoom: Checking this box will display the current zoom level.
Preset Title: Checking this box will display the number of the Preset (preconfigured camera position)
that the camera is pointing at, if so instructed. It will also display an “A” and “B” when the camera is
doing an A-B Auto Pan.
Camera Status: Checking this box will display the camera’s resolution and frame rate capabilities.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.