User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
83
To Edit the Motion Grids:
1. Click the Edit Motion Grid button, the Motion Setting menu appears.
Figure 6-26
2. Click on the image and the grid will be displayed.
3. To set up a motion area, drag a rectangle with your mouse (from top to bottom / upper- left
to lower-right). The selected areas will be highlighted in green (see image below).
4. To delete a motion area, drag a rectangle with your mouse (from bottom to top / lower-right
to upper-left).
5. Follow Step 3 to set up multiple motion areas if necessary.
6. Sets up the Sensitivity, Min Area and Motion Delay for the motion grids.
Sensitivity: Sets up the motion sensitivity for the grids. The larger the number, the higher the
sensitivity.
Min Area: This function is designed to prevent false detections caused by small objects. If you
select 2, only the object size larger than 2-grid size can be detected.
7. Click the Save and Back button to save the settings and then return to the Motion menu.