User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
73
For the Sub Server:
1. Select Sub Server in the Mode drop-down list, and check the Enable box.
Figure 6-18
2. Enter the IP address of the Main Server, and click Save.
3. When the message pops up as below, the eZ Hopper function is enabled. So, you can
now use the mouse connected to the Main Server to control this Sub Server’s OSD.
Figure 6-19
4. Follow the above 3 steps to set up the rest Sub Servers.