User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
11
5. Connect the internal power cable to the HDD.
Figure 2-4
Note: The internal power cable is connected to the Main board inside the NVR. The power
cable features two connectors, which can be used to connect to two HDDs.
6. Screw the HDDs with the brackets inside the NVR using the Washer Head Screws.
Figure 2-5
7. Screw back the housing to the NVR.