User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
10
2. Installation
2.1 Hard Disk Drive Installation
1. Make sure the NVR is power-off.
2. Unscrew the ten housing screws on the NVR, and open the housing.
Figure 2-1
3. Screw two HDD brackets on both sides of the HDDs using the Sliver Screws.
Silver Screw
HDD Bracket
Figure 2-2
4. Use the SATA Cable, and connect one end to the SATA port on the small PCB inside the
NVR, and the other end to the SATA port on the HDD.
Figure 2-3
Chapter
2