User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
140
7.5.2 Basic
User can configure the detailed camera settings, PTZ and tracking functions in this setting
page.
7.5.2.1 Camera
Figure 7-22
Channel Number: Select a desired channel for configuration.
Device Title: Enter a camera title.
Record Dual Stream: Select to enable or disable the dual streams recording function.
Record Mode: Select a recording mode from the drop-down list.
Normal+Event: Set all cameras to the Continuous and Event recording mode.
Event Only: Set all cameras to the Event only recording mode.
Record Audio: Check the box to enable audio recording on the NVR. Note that the Audio
function is unavailable for Germany.
Frequency: Select 50hz if you camera is using the PAL scanning system or 60hz for the NTSC
scanning system.