User`s manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. General Operation
- 4. OSD Root Menu
- 5. Search and Playback
- 6. Configuration
- 7. Remote Access to the NVR
- 8. Specifications
- Appendix A: Network Overview
- Appendix B: Linksys & D-Link Port Forwarding
- Appendix C: IR Remote Control
ENVR8304D-8CH / ENVR8304E-8CH
104
6.6.4 FTP
Set up the FTP server settings to enable the FTP function. The function is for users to upload
the alarm / motion recordings or snapshots from sub stream to the FTP server. You can
choose to upload either the recordings or snapshots, please see 6.3.1 Alarm and 6.3.3
Motion.
Figure 6-45
FTP Server: Enter the IP address or the host name of the FTP server.
Port: Enter the port number for the FTP server. Default is 21.
User Name: Set FTP User’s name.
Password: Set FTP password.
Confirm: Input the FTP password again to confirm.
File Name: Enter the file name.
Note: If you want to upload recordings to the FTP, please go to the Remote / Mobile setting
page to select H.264 codec.