Installation manual

ENR 400 Installation Manual
31 of 81 ENR400_ma_inst_en_rev01
Run Playback on Monitor
Selection of monitor output 1 or 2 for playback window
Primary / Secondary
Use the arrow buttons in the middle to add / remove cameras from the list
of selected monitor. Removed cameras will not be displayed at this
monitor.
Auto scan
Primary channel
"Not used" will scan all channels, which are assigned to primary monitor
in order. If a channel is selected, this channel will be displayed every
second step.
Example: "Primary Channel: Ch. 3":
Sequence: 1 > 3 > 2 > 3 > 4 > 3 > 5 > 3 > 6......
Secondary channel
"Not used" will scan all channels, which are assigned to secondary
monitor in order. If a channel is selected, this channel will be displayed
every second step.
Example: "Primary Channel: Ch. 3":
Sequence: 1 > 3 > 2 > 3 > 4 > 3 > 5 > 3 > 6......
Auto scan interval
Dwell time for interval switching in seconds
Layout
NxN type
Layout for the free definable multiview "N": 4x4, 5x5 or 6x6
Popup camera on
Event
If checkbox is active, cameras will switch to full screen in case of live
events.
Note: If secondary monitor is used, make sure to enable this monitor under > START > ENABLE SECONDARY
DISPLAY
5.4.9 Setting - Joystick
The ENR series supports EKB-200 joysticks and other HID compatible USB Joysticks.
If the system detected a joystick, ENR will show the setup options under the tab JOYSTICK.
Without connected joystick the options are greyed and not active.