Installation manual

ENR 400 Installation Manual
26 of 81 ENR400_ma_inst_en_rev01
5.4.3 Setting - I/O Device
This menu defines parameters for digital inputs and outputs of connected IP devices.
The functionality depends on connected IP - devices.
Module Setting
Device name of selected IP device (as defined in CAMERA menu)
Add, Modify,
Remove,
Device, Com port,
ID
reserved functions for IP-serial converters
Device list
List with available IP-devices, which provide I/O function
Digital Input
Monitor
The selected input is turned on if the dot is in red. By triggering the digital input device, the
related icon will light up. This is used to check if the device is correctly connected or not.
Digital Output
Simulation
The selected output is turned on if the dot is in red. By clicking on the icon, you may trigger
the digital device connecting to the system. This can be used to test if the output device is
correctly connected.
Digital input/output pins of selected I/O module
Name
Define the name of the device (input and output).
Type
Select the device type from the drop-down menu.
N/O
Normal Open.
N/C
Normal Close.
Device name
List of available devices
Input / Output list
Input monitor
Output simulator