User`s manual

72
immediately preceding the trigger. Input the desired length of pre-trigger buffer time.
-Enable Post-Alarm Buffer: Image saved internally in the camera from the time
immediately after the trigger condition has ceased/been reset. Input the desired length
of post-trigger buffer time.
Event Handler
-Trigger output: Check this box to enable trigger output.
-Play Sound: Check this box to get the sound notification signal when an event is
triggered. Set duration time of sound notification.
-Go PTZ: Select “Preset” and enter preset number to go preset point when an event is
triggered. Select “Tour” and enter tour number to go the tour when an event is
triggered.
-Send mail to emergency contact(s): Check this box to send mail to emergency
contact(s) when an event is triggered.
-Attached snapshot: Check this box to attach snapshot in the mail when an event is
triggered.
-Send snapshot to FTP server: Check this box to send snapshot to FTP server when an
event is triggered.
-Go to Map Layer: Goes to the map layer of the device when an event is triggered.
Press button to print out current page.
Press button to apply all the settings.
Press button to cancel all the settings.