Technical data

EverFocus Electronics
EDR system configuration
Add new EDR system
A new EDR system can be added at any time. Build up a connection to configure the system
or to view the video images.
Attention!
The following settings must be set correctly and exactly according to the
EDR system in the PowerCon Station configuration dialogue prior to
building up the connection to the EDR system:
• Hostname (respectively IP address)
• Host port
• DVR type
• Software version
• Software language
There may occur mistakes in configuration data transfer, especially if the DVR type and
software version settings are not set correctly. This can result in an EDR system
malfunction.
The available EDR systems are listed in the system list.
• Move the mouse to the list and click the right mouse key to open a context menu.
• Select New system and confirm the security check with Yes. PowerCon Station
generates the basic data for the new system. This process can take several seconds.
When the process is completed, the new system is listed first place on the system list with
the description <NEW> and you can start the configuration.
Configure an existing system
Note:
The configuration settings of the EDR systems are described only in shortened form in the
PowerCon Station documentation. Detailed information about the EDR system
configuration can be found in the EDR’s documentation. In any case, please play attention
to the security notes and information about approved and recommended applications
indicated in that documentation.
The EDR system configuration can be carried out completely in the PowerCon Station
configuration dialogue. All settings are summarized on various registers and arranged in
groups. If you work on the registers by turns from left to right, you cannot overlook or
forget any settings.
After completion and transfer of the configuration to the EDR system, please always check
the correct function of all components and settings and make sure that the EDR system
works as intended.
• Select Configuration from the DVR menu to open the Configuration menu.
• Select the EDR system whose configuration is supposed to be worked on from the
system list on the left side.
• Select one of the registers on top to open and work on the respective task