User`s manual

EDN Plus Series

6.2 Setting Up the Playback Function

Note that the Playback function will not be active until the user has inserted a micro SD card in the

camera’s micro SD card slot. The card may also have to be formatted in the Settings submenu.

Micro SD Card Slot

6.2.1 Preparing the Micro SD Card

Once you insert a functional Micro SD card into the slot, the Playback button on the Live page

should become active within seconds (see section 6.2.2 below – the grey letters should turn white).

IF NOT, do the following:

1. From the Live page, click Settings > System > SD Card. If no card has been inserted yet, the

Remove button should be faded, indicating that no card is being detected. (If a card is inserted,

and the Remove button is still faded, pull the card out and re-insert it.)

2. Slide the card into the slot until it clicks into position.

3. The Remove button should become active within a few seconds, indicating the card is active.

4. If the Remove button stays faded, click the Format button to format the card. NOTE: All data on

the disk will be deleted if the Format button is clicked.

6.2.2 Testing the Playback Function

1. Once the micro SD card is detected by the system, the button (inactive) will

turn to (active).

2. To test the Playback function (this is not required), set up a “Manual Trigger” Recording Event

by clicking Settings > Event > Event Settings.