Instruction manual

56
HD Full:
Figure 4-15 Alarm & Event Menu – Event - HD Full
Note: All settings in this menu are only relevant, if the DVR does not work in OVERWRITE mode (check
box RECORD OVERWRITE off in RECORD menu, chapter 4.4.1 RECORD).
Log Check box to record events in the log.
Buzzer Check box to enable the buzzer when hard drive is full (recommended if the Record
Overwrite function is disabled. See Section 5.4.1).
Email Notify Check box to enable email notification when HD is full. Email operation requires that
valid email settings have been entered in the Network Setting/Email setup screen.
Network Alarm Check box to send out a network alarm to client PC. (requires PowerCon software
and setting up Alarm Server in Network Setup menu)
Alarm Output Selection of relay output as event reaction “NONE” (not active), “1” ~ “4” for the relay
(in 4 channel version is only 1 relay available).
Output Type Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will be continuously active until user presses the “Enter” key or
resets the alarm remotely.
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then continues for the set
time duration.
Timeout
Duration
The amount of time the alarm condition continues when the HD is full. Duration
selectable from 1 to 150 seconds.