Instruction manual

depend on DVR setting)

Alarm Output Selection of relay output as event reaction “NONE” (not active), “1” ~ “4” for the relay

(in 4 channel version is only 1 relay available).

Output Type Output action when motion is triggered.

Timeout Alarm output lasts for the set time duration.

Permanent Alarm will remain active until user presses the “Enter” key or

resets the alarm remotely.

Transparent Alarm output remains as long as the alarm input is active.

Trans+Timeout Alarm output continues until event ends, then continues for the

set time duration.

Timeout Duration Time duration selectable from 1 to 150 seconds.

Edit Motion Grid Press this button to edit the motion grid (See Figure 4-5 Camera Menu –

Motion Grid

Setting).

Sensitivity Set the threshold value for sensitivity within the grids. Select from 1

(lowest) to 10 (highest).

Min Area To avoid false detections by small objects this value defines how many

grids have to be exceed threshold before generating a motion event. Select a value

between 1 (default) to 5 grids.

Preview Preview the motion grid.

Set All Press this button to select the entire area.

Clear All Press this button to clear all the grids selected.

Save & Back Press this button to save the motion grid setting and return to motion

setting menu.

Cancel Press this button to cancel all changes and returns to the motion setting

menu.

How to select motion grid by mouse

1) Select lower-right grid.

2) Select upper-left grid.

3) The area between upper-left and lower-right grid will be selected.

How to select motion grid by front panel

1) Press Enter key to enter motion grid.

2) Use arrow keys to select one corner of desired area

3) Press Enter key at the starting point.

4) Use arrow keys to select motion area.

5) Press Enter key twice at the end point, and the area will be selected.