User's Manual

EQN2200
33
There are 5 possible motion trigger areas, which can be distinguished by 5
different colors. Check the Enable checkbox to enable event actions related to that
area.
For each area, you can set the event action in response to motion detection in that
area. Event actions can be set in “Event” section.
In addition, you can set the Sensitivity level for the motion trigger separately for
each area by selecting from 1 (low), 2, 3, 4, 5, 6, 7, 8, 9 to 10 (high).
4.7.3 Alarm
Alarm Output Setting
Contact Type: Normal Close, Normal Open
Duration Time: Select duration time of alarm output from 5 sec, 10 sec, 20 sec, 30
sec, 60 sec, 2 min, 3 min and 5 min.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
Pre/Post Alarm Setting
This function is used to be able to review what happened immediately before and
after a trigger, e.g. 5 seconds before or after a motion has been detected, or after