Owner`s manual

ManualsBrandsEverex ManualsHome building and DecorEverdisk

5.2.2 Two Internal Drives

If

you

plan

to

have

two

internal

drives

attached

the

controller,

use

the

following

additional

instructions:

1.

Make

sure

the

controller

is

configured

for

the

installation

of

two

drives.

Refer

to

Section

4.2

for

instructions

on

how

to

configure

the

controller.

2.

Make

sure

the

drive select

switch

and

terminating

resistor

on

each

internal

drive

are

adjusted

according

to

instructions

in Section

3.1

and

3.2.

3.

Connect

the

20-pin

data

cable

from

drive

1

to

the

12

connector

and

the

20-pin

data

cable

from

drive 2

to

the

13

connector.

Then

connect

the

34-pin daisy-chain

cable

to

the

11

connector

(see

Figure

11).

4.

If

possible, place

the

drives side

by

side

on

top

of

the

floppy

drive

or

a

tape

drive. DO NOT try to stack two

hard

disk drives on top of one another, as this may cause

the system to overheat!

34