Owner`s manual

ManualsBrandsEverex ManualsHome building and DecorEverdisk

Section

2:

Getting

Started

The

following

Quick

Installation

subsections

are

for

experienced

PC/XT

users.

First-time

users

should

follow

the

more

comprehensive

instructions

in

Sections 3

through

5

of

this

manual.

2.1

Quick Installation (Internal Drive)

1.

Configure

the

drive

as

drive

1

or

drive

2,

and

check

if

you

need

to

disable

the

drive's

terminating

resistor.

2.

Configure

the

SWl

jumper

block

for

the

type

of

drive

you will

connect

to

the

controller.

3.

Attach

the

20-pin

and

34-pin

ribbon

cables

to

the

controller.

4.

Install

the

controller

in

your

system.

5.

Install

the

drive

in

your

system.

6.

Attach

the

other

end

of

the

20-pin

and

34-pin cables to

the

drive;

attach

an

available

4-wire

power

cable

from

the

power

supply

to

the

drive.

7.

Reinstall

all cables

and

turn

ON

the

computer.

8.

Format

the

hard

disk

drive

following

the

instructions

in

Section

6.

8