Owner`s manual

DEVICE = EMM.SYS
If you have any other Everex memory board model
numbers, you must use the [port,page] parameter in the
EMM.SYS command line as follows:
DEVICE
= EMM.SYS [PORT,PAGE]
For the [POR T,P AG E] parameter, type in the port address
of the EMS memory, beginning at a specific logical page
(indicate the port and page in hexadecimal values). For
example, you would type in a command line like the
following:
DEVICE
= EMM.SYS 258,00
In this example, the port address of the EMS memory
begins at 258, with the logical page starting at 00. All of
these parameters are explained in more detail in the last
section of this addendum called, "EMM.SYS Command Line
Arguments."
NOTE: If you have a combination of Everex memory boards,
for example, an EV-165 and an EV-158A, you would use the
more comprehensive EMM.SYS command line similar to the
following:
DEVICE
= EMM.SYS 258,00
2