Owner`s manual

5.3.2 ESPOOL.EXE Parameters
When you install ESPOOL.EXE by typing ESPOOL [Enter],
the resulting print spooler will be 64KB in size, located in
base memory, and direct the contents of the spooler to
parallel
port LPT 1. However, you can change these
parameters if you want to change the size of the print
spooler, locate it in another type of memory, or direct the
contents of the spooler to another port besides LPT 1 paral-
lel port.
The ESPOOL.EXE command line uses this format:
[path ]espool [/b:bbb] [Ie] [Ix] [/p:o] [ls:n[,b,p,d,s,h]] [lr]
Where:
[path]
[lb:bbb]
[Ie ],[/x]
54
represents the subdirectory path where the
ESPOOL.EXE program will be located. If
ESPOOL.EXE is located in the root directory,
you
can omit this parameter.
represents the size of the print spooler. Valid
sizes
are lKB to 15360KB; if you omit this
parameter, the spooler size will be 64KB.
represents what type of memory you want to
locate
your print spooler in. Normally,
omitting these parameters will result in the
print spooler located in base memory. Use
the [Ie] parameter if you want the spooler in
extended memory, and use the [Ix] parameter
if you want the spooler in expanded memory.