Owner`s manual

frame address at C400 (Hex). If the page frame address is
occupied,
it will try to look for 64KB address space in as-
cending order up to EOOO (Hex). If this fails, the "No room
on motherboard for page frame" message will appear, and
the search will terminate.
3. device = \everex\emm.sys /e e800 268,30
This EMM.syS command line looks for the EMM.syS file in
the \everex subdirectory, enables interrupt 67 (Hex) chaining,
and defines expanded memory at segment address CSOO, port
address 268, page 30. If port address 268 is not found, it will
try to look for port addresses 2A8, 2B8 and 2E8.
4. device = emm.sys 258,00 268,00 208,00 218,00
This EMM.syS command line selects 258, 268, 208 and 218
(Hex) port addresses, with all ports assigned with EMS
logical starting page 00 (Hex). Use this command line when
you install two RAM 3000 Deluxe boards, with both boards
set
for EMS mode only. NOTE: Make sure the EMS I/O
ports on the first board are 25.8 and 268, and the second board
are 208 and 218.
44