Owner`s manual

3. When the memory test points out the location of any
bad chips (bad chips are shown blinking), check the
chips at the locations represented on the screen to
ensure
the chips are installed correctly (did you bend or
break the chip pins or improperly orient the chip?); if
the chips are installed properly, you must replace the
bad chips.
4. When you finish the testing procedures, press [FlO] to
leave the EVI59.EXE program.
Running the SETUP Program
Once the RAM 3000 Deluxe board testing is completed, run
the SETUP program on the IBM AT Advanced Diagnostics
diskette.
This program informs the AT of the new memory
expansion board so application software can access the
board.
1. Boot up your system with the IBM AT Advanced Di-
agnostics diskette
in drive "A."
2. Choose the SETUP option.
3. Follow the instructions as they appear on the screen.
NOTE: AT compatibles have various methods
of running the
SETUP program; please check your owner's manual to find out
how to
run the SETUP program for your particular machine.
38