Owner`s manual

Section 4: Installation
When you finish configuring your RAM 3000 Deluxe, you
can now install your board into your system.
4.1 Physical Installation
1. Turn OFF the power to the computer and disconnect
all cables attached to the system unit. Make sure NO
power goes to your system.
2. Remove the retaining screws that hold the cover on
your system. Slide the cover forward. When it stops
sliding, tilt
the cover up and lift it away. Refer to the
next figure.
rr ---
111111111i!!!!!!!!!!!!!!!!I!I!!!!!!!!
Figure 7: Removing the System Cover
33