Owner`s manual

3.1 Default Settings
The RAM 3000 Deluxe leaves the factory in this default
configuration (see Table 1 on the following page for the
jumper and dipswitch default settings):
1. There are no memory chips installed.
2. It assumes one memory bank of RAM chips are
installed.
3. There is no memory space defined for base andlor
extended memory upgrading.
*
4. The starting memory address is (lOOOOOH ) or 1 MB.
5. The 2 EMS 110 Ports are set at Y258 and Y268 (where Y
can be 0, 4, 8, or C) port addresses.
6. The EMS 110 Ports are disabled.
7. The EMS data transfer size is 8 bits wide.
8. The memory parity checking mode is enabled.
If you do not want to modify the default configuration, you
can proceed to install your RAM 3000 Deluxe. If you need
to
change any settings on the RAM 3000 Deluxe, use either
the EV159.EXE configuration program on your RAM 3000
Deluxe utility diskette (see
Section 3.2: Configuring With
Software),
or utilize the tables in this manual (see Section 3.3:
Configuring Without Software
and Appendix 2: Dipswitch Setting
Tab/e) to help configure this board; we suggest using the
EV159.EXE software program.
*
10
"lOOOOOH" means 1 megabyte memory address in
hexadecimal.