Specifications

EN OPERATION

Tennant E5 (03--08)

MACHINE SETUP

INSTALLING BRUSH

FOR SAFETY: Before installing brush, turn off

machine and unplug power cord from wall outlet.

1. Remove the brush idler plate from the brush base.

T urn the idler plate locking knob

counter--clockwise to remove (Figure 1).

2. Connect the slotted end of the brush to the drive

hub (Figure 2).

FIG. 1 FIG. 2

3. Connect the idler plate to the brush and reinstall

the idler plate. Make sure the idler plate hooks

engage the brush base and that the locking knob

is secure (Figure 3).

FIG. 3

NOTE: If storing the machine for an extended period,

remove the brush to prevent a flat spot.

FILLING SOLUTION TANK

1. Lift the cover and remove the solution tank from the

machine(Figure4).

2. Fill the solution tank with 19 L of clean water (50°C

maximum temperature) (Figure 5). Partially fill if

unable to lift a full tank.

FIG. 4 FIG. 5

ATTENTION: Do not use the recovery tank to fill

the solution tank. Dirt from the recovery tank may

cause damage to the solution pump.

W ARNING: Fire Or Explosion Hazard, Do Not

Use or Pick Up Flammable Materials.

3. Submerge the solution hose screen into the

solution tank and close the cover (Figure 6).

FIG. 6

Home

Find...

Go To..