User Manual
2120
Assembly, Operation & Maintenance InstructionsAssembly, Operation & Maintenance Instructions
CHECKING THE BURNERS FOR FLAME STABILITY:
Visually check the burner ames for correct function when the unit’s operating by
inspecting the burner ame / ames with the cooking plates & grills removed. A good
ame should be blue with some yellow tipping.
Note: take care when viewing the burner operation not to lean into the ame, failure to
do this may result in personal injury.
CLEANING YOUR GAS GRILL:
Its recommend that you clean your gas grill using only a mild washing liquid solution, avoid
using abrasive or solvent based cleaners these may damage the nish of your gas grill
and may void your warranty.
Note: Prior to cleaning your grill please ensure your grill is at cool temperature. BURNER
Brush the outside of the burners with a sti brush to remove rust and dirt. Make sure all
ports are open.
GAS SUPPLY
LEAK TESTING GENERAL: Although gas connections on the grill are leak tested prior
to shipment, a complete leak test must be performed at the installation site. Before
each use, check all gas connections for leaks using the procedures listed below. If the
smell of gas is detected at any time, you should immediately check the entire system
for leaks.
BEFORE TESTING: Make sure all packing materials have been removed from the grill.
Make a solution of one part liquid detergent and one part water. You will need a spray
bottle, brush, or rag to apply the solution to the ttings. For the initial leak test, make
sure the Liquid Propane cylinder is full.
TO TEST
1. Turn the burner valves o.
2. Turn the Liquid Propane cylinder valve counterclockwise to open the valve.
3. Apply the soap solution to all gas ttings. Soap bubbles will appear where a leak is
present.
4. If a leak is present, immediately turn the gas supply “OFF” and tighten leaky ttings.
5. Turn the gas back “ON” and recheck.
6. Should the gas continue to leak from any of the ttings, turn the gas supply “OFF”
and contact customer service at everdurebyheston.com
7. If there is evidence of excessive abrasion or wear, or the hose is cut, it must
be replaced prior to the outdoor cooking gas appliance being put into operation.
Only those parts recommended by the manufacturer should be used on the grill.
Substitutions will void the warranty.
BARBEQUE AND HOOD
1. Wipe over the outer areas of the barbeque and hood with a clean cloth.
STAND
1. Check all fasteners for tightness and re tighten where necessary to ensure rigidity of the
structure.
2. Wipe over barbeque stand with a clean cloth. Add a little oil or grease to all moving parts.
If connected to the barbeque, check the screws holding the barbeque and stand
together are all tted and tight. Wear and tear to this barbeque can be reduced by
using a barbeque cover and storing out of the weather when not in use.
Yello w
Blue