Instructions / Assembly
HOMEDEPOT.com
Please contact 1-877-297-6069 for further assistance.
Installation
1
PREPARING FOR INSTALLATION
□ This 24 in. septic tank riser cover (A) will t most 24 in.
installed risers. Test t the riser cover (A) to ensure it is
correct for your riser.
□ Clean the sealing surface of your riser.
□ Remove the hardware pack containing the four square-drive
screws (B) from the back of the riser cover (A).
A
B
2
INSTALLING THE RISER COVER
□ Place the riser cover (A) on your riser. Ensure the rubber seal
is making a seal with the top of your riser.
□ Using the four screw holes in the riser cover (A) as a guide,
drill four 3/16 in. holes through your riser.
NOTE: Some risers may require the use of holes other than the molded
screw holes in the riser cover. For these risers, use the two additional
drill points molded on the top of the cover.
□ Install the screws (B) with a #3 square driver.
□ For access to your riser, remove the screws (B) and cover (A),
then reinstall.
A
B
Safety Information
WARNING: Failure to properly secure the riser cover will create a serious safety risk. Follow these installation instructions carefully.
Warranty
This product is warranted to the original consumer purchaser to be free from defects in material and workmanship for a period of one year from the date of
purchase. For additional details and questions, please contact Everbilt Customer Service at 1-877-297-6069.
TOOLS REQUIRED
Drill with 3/16 in. drill bit #3 Square Driver
PACKAGE CONTENTS
A - Riser Cover x1 B - Square drive screws x4
Use and Care Guide
18 in. Sump Pump
Basin Lid
Item # 1000027540
Model # SF60913
WARNING: Failure to install basin cover as shown will create a safety risk. Install cover as shown.
This 18 in. sump basin cover
will fit many 18 in. sump
basins. Test fit the cover to
make sure it is correct for
your sump basin.
Place the cover on your
basin. Make sure that your
sump’s discharge pipe and
your pump’s power and float
cords pass through the large
slot in the cover.
Using the wrench, secure
the cover with the bolts and
washers supplied.