Use and Care Manual

13 WWW.HOMEDEPOT.COM
Please contact 1-844-241-5521 for further assistance.
Deep Well Installation (continued)
6
Sliding a well seal over the rigid
pipe
7
Attaching a elbow & tee to the
rigid pipes
 Remove the pipe clamp and slide a well seal (sold separately)
over the rigid pipes and onto the well casing. The rigid pipe
should extend approximately 12 in. from the well seal, depending
on the height of the pump.
NOTE: DO NOT allow the assembly to slide down into the
well. Tighten the well seal until rubber gaskets are tight
against the well casing and the rigid pipes.
 Attach a 1 in. elbow and a 1-1/4 in. tee (both facing the pump)
to the pipes extending from the well seal.
 Attach rigid pipes to 1 in. elbow and 1-1/4 in. tee separately.
8
Connecting rigid pipe to the pump
body
9
Connecting two flexible plastic
pipes
 Mount the pump as close to the well as possible.
 Attach two section of rigid pipes (1 in. drive, 1-1/4 in suction) to
the pump body.
NOTE: If using PVC pipe to connect, a 1 in. x 3 in. nipple is
required.
 Connect a flexible plastic pipe (1-1/4 in.) to the 1-1/4 in. rigid
pipe.
 Connect a flexible plastic pipe (1 in.) to the 1 in. rigid pipe.
 Connect the other end of the plastic pipes to the rigid pipes
extending from the well seal.
 Tighten the flexible plastic pipe two ends with clamps. Ensure
the pipe slopes slightly toward the well (to prevent air trapping in
the pipe).