Use and Care Manual

11 WWW.HOMEDEPOT.COM

Please contact 1-844-241-5521 for further assistance.

Deep Well Installation

MATERIALS REQUIRED (NOT INCLUDED)

One can PVC cement & primer (read instructions carefully) One well seal with vent plug

One can thread compound (read instructions carefully) Foot valve

Thread tape Priming tee and plug

Rigid pipe Relief valve

Check valve Adaptor

Flexible plastic pipe/clamps Tank

Elbow Tank tee

Nipple

WARNING: All joints and connections must be AIRTIGHT. A single leak will prevent the proper operation of the pump. Wrap thread tape

clockwise on all threaded connections. For all non-threaded connections, you must use PVC purple primer and PVC cement to ensure airtight

seals. Measure all pipe lengths before attaching.

NOTE: The ejector kit from the factory is for shallow well application. For deep well installation, the venturi tube (B) (J32P-18/#11) and

nozzle (C) (#02) have to be installed.

REPLACING AN EXISTING PUMP

WARNING: Risk of electric shock. Can shock, burn or kill. Disconnect power to pump before working on pump or motor.

1. Drain and remove the old pump and the ejector in the well. Check pipe for scale, lime, rust, etc., and replace it if necessary.

NOTE: Your old ejector (in the well) can’t be properly matched to your new pump. You must use the included ejector to your new pump.

2. Refer the following instruction to finish the new pump installation.

NEW DEEP WELL INSTALLATION (4” OR LARGER WELL)

Removing the pre-assembled

nozzle and venturi

 Removing the pre-assembled ejector first then removing the pre-

assembled nozzle and venturi.

 SKU 1001 480 251, Turn the venturi tube (#13) counter

clockwise.

Remove the venturi tube (#13) and nozzle (#04) with an O-ring

from the ejector.

 SKU 1001 480 255, Turn the venturi tube (#14) counter

clockwise.

Remove the venturi tube (#14) and nozzle (#04) with an O-ring

from the ejector.