Installation Guide

ManualsBrandsEverbilt ManualsFaucet Parts1-1/4 in. Sink Drain Pipe Zinc Slip-Joint Nut with Rubber Reducing Washer

SLIP JOINT NUT

INSTRUCTION GUIDE

Measure and cut wall tube to desired length

Position slip nuts and slip washers onto wall tube

Insert wall tube into the waste connector and

hand tighten the existing waste connector slip nut

Position the slip nut and slip washer onto the vertical tailpiece

(Use reducing washer if tailpiece is 1¼”)

Place J-bend onto the wall tube and tailpiece, and hand tighten the slip nuts for alignment

Fully tighten all slip nuts and test for leaks

©2020 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out

of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is

expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.

Oatey.com

Summary of content (1 pages)

PAGE 1
INSTRUCTION GUIDE SLIP JOINT NUT 1 Measure and cut wall tube to desired length 2 Position slip nuts and slip washers onto wall tube 3 Insert wall tube into the waste connector and hand tighten the existing waste connector slip nut 4 Position the slip nut and slip washer onto the vertical tailpiece (Use reducing washer if tailpiece is 1¼”) 5 Place J-bend onto the wall tube and tailpiece, and hand tighten the slip nuts for alignment 6 Fully tighten all slip nuts and test for leaks ©2020 Oatey SCS.