Instructions / Assembly

airgaps are created between the Everbilt Insulation and the wall/ or insulation and the sheet rock
within the furring strip cavity.
Radiator:
Benefit: Radiant Reflector
Installation: Cut Everbilt Insualtion to the size of the hot water radiator. Install it directly to the wall
without it touching the radiator or plumbing. Use double sided tape, Velcro or spray adhesive to
hold the product securely in place.
Water Heater:
Installation: Cut 4 x 2” wide strips and double wrap these around the heater an equal distance apart
to create a cavity and fix in place with foil tape. Wrap the Everbilt Insulation around the heater
completely and seal the overlaps with Everbilt foil tape.
Do not install over the access panel, controls or the top and bottom of the tank.
Please always read the heater manual and follow any manufacturer’s guidelines regarding installing
insulation.
Workshop/ Storage Room:
Installation: Recess the Everbilt insulation to the middle of the wall cavity (2” x 4”) and cover with
drywall and or other covering. The required cavity is created between the insulation and wall and
the insulation and internal panel, inside the stud cavity.