Installation Guide

1 2 3

1 2 3 4 5

7. Adjust the flush volume of the flush valve

8. Preparing the push button

Installation (continued)

A. Half flush volume adjustment: Adjust the half float up and down while pressing the clip. Decrease half

flush volume by moving half float upward and increase half flush volume by moving half float

downward.

B. Full flush volume adjustment 1: Adjust the full float up and down while pressing the clip. Decrease full

flush volume by moving full float upward and increase full flush volume by moving full float downward.

C. Full flush volume adjustment 2: Decrease full flush volume by moving the full adjustor upward and

increase full flush volume by moving full adjustor downward.

A. Close the water tank lid and measure the distance from the flush button (B) to the top of the water

tank lid with a tape measure, and record it as L1.

B. Loosen the lock nut (B1), unscrew the push rod (B2), and remove the positioning plate (B3).

C. Measure the length from the end of push rod (B2) with a tape measure, mark it at the L position

(L = L1-20mm) with a pencil, and cut off the excess with scissors.

D. Replace the push rod (B2) on the button (B) and tighten the lock nut (B1).

E. When L≥100mm, a positioning plate (B3) must be installed on the push rod (B2).The distance

between the position of the positioning plate and the lower end of the push rod is L3 (L3 = 40mm);

when L<100mm, there is no need for the positioning plate (B3).

NOTE: When adjusting the full float, the full adjustor must be set at scale 5. When adjusting full adjustor, the full float must

be set at scale 1.

Full Adjutor

3x magnification

Full

card

Full adjusting

float

3x magnification

Half

card

Half adjusting

float

3x magnification

Reserved part

L=L1-20mm

Pressure

bar end

Note: when L≥100mm, it needs to be equipped with the localizer

when L <100mm, without the localizer

L2=L1-2mm

L3=40mm

HOMEDEPOT.COM

Please contact 1-800-305-1726 for further assistance.