Instructions / Assembly

Thin Self-Adhesive Magnetic Catch
Model 931478500 Item 1008119702
REVIEW all instructions before you begin.
USING SCREWS TO INSTALL
Determine the installation
location. Measure and mark
screw holes with a pencil.
Drill pilot holes for screws if
necessary.
Attach Catch (A) and Strike
Plate (B) with Screws (C).
BEFORE YOU BEGIN
The catch can be installed two ways—by using screws or by using adhesive strips.
The catch can be installed on the top, bottom, or side of the cabinet, drawer, shutter, or anywhere you need secure hold in a narrow space.
1
TOOLS REQUIRED
Phillips-head screwdriver
Pencil
Tape measure
Oponal: Electric drill with drill bit
C
(8) Screws
PACKAGE CONTENTS
A
(2) Catch
B
(2) Strike Plate
D
(4) Adhesive Tape
2
USING ADHESIVE TO INSTALL
Determine the installation location. Clean location surfaces thoroughly.
Measure and mark the position for installation.
Peel off backing from one side of Adhesive Tape (D) and affix to backs of Catch and Strike Plate.
Peel off backing from second side of Adhesive Tape. Firmly press Catch and Strike Plate to installation location.
To ensure best adhesion, keep Catch and Strike Plate closed for 12-24 hours.
•
•
•
•
•
•
•
•