User Manual

3
HOMEDEPOT.COM
Please contact 1-800-305-1726 for further assistance.
Pre-installation
CHOOSE YOUR HARDWARE
PLANNING INSTALLATION
TOOLS REQUIRED
HARDWARE PACKAGE CONTENTS
AA
BB
CC
DD
Panhead Screw (#12 x 2 in.)
Anchor (1/4 in.)
Bolt (3 in.)
Toggle (3/16 in.)
20
20
20
20
Part QuantityDescription
Screwdriver Drill Pencil Tape Measure Level HacksawStud Finder
AA BB
CC DD
Secure to the wall with panhead
screws (AA) at stud locations.
Drill 1/4 in. holes, insert wall
anchors (BB) and secure to the
wall with panhead screws (AA).
STUDS
CONCRETE
AA
BB AA
1. Start your project by installing Base Kit rst (instructions located in base kit box) before moving on to the following instructions.
2. Measure the closet width and plan the layout. See the “Plan Your Closet Layout” section for illustration examples.
3. Select the correct hardware for assembly.
4. Use stud nder to locate the studs and mark. It is recommended to mount hang tracks onto studs.
5. For creating larger layouts that include multiple hang tracks, install Base Kit hang track rst then install additional hang track extensions
ensuring additional hang track is level and in line with previously mounted hang track(s).
WARNING: This product can expose you to chemicals, including lead, which is known to the
State of California to cause cancer and birth defects or other reproductive harm.
For more
information go to www.P65Wamings.ca.gov
NOTE: Hardware not shown to
actual size.