Instructions / Assembly

Tools Required:
Screwdriver
Adjustable Wrench
Seat Wrench
Stem Removal Tool
Rebuild Kit Includes:
1 Pair Hot/Cold Stems (Interchangeable)
1 Diverter Stem
1 Socket Removal Tool (not pictured)
1 Pair Handles with Buttons and Screws
1 Diverter Handle with Button and Screw
3 Two Piece Flanges (Sleeves and Flanges)
1 Bibb Seat (for Diverter)
Helpful Tools:
Handle Removal Tool
SHOWER FAUCET REBUILD KIT FOR PFISTER
®
INSTALLATION INSTRUCTIONS
1006965267
Installation Instructions:
Remove Old Parts:
1. Turn off water supply to the shower faucet. Once the water supply is shut off, turn the shower faucet on to release water pressure;
then turn the faucet off.
2. Remove old handles by prying off handle buttons, removing screws, and lifting off handles.
3. Remove old flanges by loosening set screws, then remove old sleeves by unthreading from valve stems.
4. To remove old stems, unscrew bonnets and pull out stems, using the socket removal tool.
5. Insert seat wrench into faucet valve and turn counter-clockwise to remove old bibb seats.
Install New Parts:
1. Place new bibb seat (for diverter stem) into shower faucet valve and tighten, using a seat wrench. Do not overtighten.
If your kit includes gaskets (or o-rings): Before installing each stem, thread gasket (or o-ring) on the bottom of each stem bonnet.
2. Install new stems by threading each stem into the faucet body. (If necessary, use the socket removal tool to tighten.
Place socket removal tool on stem, use wrench to tighten.) Turn on water supply and check for leaks.
3. Install new sleeves by threading onto stems. Install new flanges by threading onto sleeves and tightening to wall.
4. Install new handles: pry off handle button, secure handle with screw, replace button.
5. Turn on shower faucet and check for leaks.
Handles
(Hot, Cold and Diverter Handle
with Buttons and Screws)
Flanges
Sleeves
Stems
(Hot, Cold and Diverter)
Bibb Seat
Handle Button