Specification

76
Light Gauge Metal (20-25)
Product #220
Wafer Head STREAKER
®
(1 OF 2)
APPLICATIONS
 Steel studs to 20 to 25 gauge track
 Metal K-lath, wire lath, wood grounds, and metal studs to
20 – 25 gauge steel
 Other metal-to-metal applications that require low profile head exposure
SPECIFICATIONS
 Gauge – #8
 Lengths – 9/16” to 3”
 Head Type – Wafer
 Recess Type – #2 Phillips
 Thread Type – Double Lead
 Finish – Gray Phosphate or Clear Zinc
 GRABBER
®
screws are manufactured in an ISO 9002 and ISO 14001
certified and approved factory, and are approved by ICC ESR report
ESR-1271.
PRODUCT FEATURES
 A fine thread screw for metal-to-metal applications
 Low profile head exposure
 15 threads per inch
 Super sharp, 23° STREAKER
®
point, designed to penetrate steel quickly
and easily
 #2 Phillips recess drive
 Wafer head provides a greater bearing surface than other fasteners
INSTALLATION GUIDELINES
 Use a standard screwgun with a depth-sensitive nose piece. Suggested
screwgun specification for optimal performance – 4 amps minimum and
RPM range of 0 to 4,000.
 The Wafer head is fully seated when the head is flush with the work surface.
 Overdriving may result in failure of the fastener or stripout of the
work surface.
 The fastener must penetrate beyond the metal a minimum of three
thread pitches.
Attaches metal lath to wood or to 25-20 ga. steel studs and framing.
Finish - Clear Zinc and GRABBERGARD Gray