User's Manual

2348 Walsh Avenue
Santa Clara, CA 95051
[e-mail]
www.everactive.com
Note: The Boomerang device is used internally for Everactive products and services – it is not sold
separately to other customers. The following User’s Guide is an instruction set used to program and
control Boomerang to prepare it for integration with Everactive products or troubleshooting.
Hardware needs:
1. Wake-up dongle with programmed firmware image
2. Window 10 PC w/ USB port
Connecting the DUT to your PC:
Connect the DUT to a USB 3.0 port on your PC or a USB-powered HUB. A green LED will blink while the
DUT establishes a COM port. The COM port can be found in the Device Manager under USB Serial
Device. At this point you should be ready to run commands.
Figure 1: Device Manager
Operating the Wake-up Dongle using Python:
Install the python package (internal to Everactive)
- pip3 install -i http://python-registry.psikick.com --trusted-host python-
registry.psikick.com wakeup_device
Upgrade the wakeup-device package directly from the internal python registry