User's Manual

2348 Walsh Avenue
Santa Clara, CA 95051
[e-mail]
www.everactive.com
Note: The Silver Glade hardware is part of a service package sold by Everactive and is not for sale as an
individual standalone product and as such is not open for end customers to program or configure. The
following User’s Guide is an instruction set used to program and control Boomerang to prepare it for
integration with Everactive’s service, or test and debug.
Hardware setup for test mode
Hardware needs:
1. SVG Prog 2.0 Programming board
2. Silver Glade Hardware
3. Everactive USB-C attachment cable
Note: for programming and SW control, harvesting mode is bypassed, eliminating the need for the
energy harvesting puck. Later sections will describe the install of a Silver Glade unit onto a motor.
Connect SVG Prog. 2.0 into a USB 3.0 input on a computer or USB Hub. Then connect the Everactive
USB C attachment cable from the IO ‘MAIN USB-C’ to the USB C input on Silver Glade (see Figure
below).
Figure 1: Silver Glade connected to programming device