User Manual

46
DARNING STITCH
3.5~7.0
1.5~2.0
D
B-29
B-30
1 Select pattern 29 or 30 from the Group
Patterns "B" to get the darning stitch.
Change the presser foot to the buttonhole
foot.
1
2 Baste the upper fabric and the reinforcement
fabric together. Select the width of the
pattern by using the stitch width button.
Lower the presser foot over the center of the
tear.
3. Pull the button holder to rear. Set the button
guide plate on buttonhole foot to the
desired length.
4. The size of the darning cycle is variable.
However, the maximum stitch length is
2.6cm (1 inch) and the maximum stitch
width is 7mm (9/32 inch).
a. The length of darning pattern.
b. The width of darning pattern.
4
Start
a
b
StopStop
a
Start
b
2
3
4
1
NOTE
Make no
gap here
3
2