User Manual

10. Do not pull or push the fabric while sewing. This can result in needle
breakage.
11. Switch the machine off ("O") when making any adjustments in the needle
area, such as threading or changing the needle, threading the bobbin, or
changing the presser foot, and the like.
12. Always unplug the machine when performing cleaning or maintenance work
such as replacing the sewing light or when making any other user
maintenance adjustments mentioned in the instruction manual (disconnect
the power plug). Cleaning and maintenance work must not be carried out by
children without supervision.
13. Never drop or insert any object into any openings.
14. Use this machine only in dry and protected areas. Never operate the
machine in a damp or wet environment.
15. Do not operate the machine where aerosol spray products are being used or
where oxygen is being administered.
16. To disconnect, turn the power switch to ("O")(off), then remove the plug from
the outlet. Do not unplug by pulling the cord, instead grasp the plug to pull it
from the outlet.
17. If the supply cord of the foot control is damaged, it must be replaced by the
manufacturer or an appropriate service agent or a similar qualified person in
order to avoid endangerment.
18. Never place anything on the foot control.
19. When replacing the light bulb, always use the same type.
20. The machine may only be used in combination with a foot control of the type
C-8001.
21. The sound pressure level during normal operation is lower than 75dB(A).
22. This machine is provided with double insulation (except U.S.A/Canada). Use
only identical replacement parts. See instructions for Servicing of double-
insulated products.
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product nor
should a means for grounding be added to the product. Servicing a
doubleinsulated product requires extreme care and knowledge of the system and
should only be done by qualified service personnel. Replacement parts for a
double-insulated product must be identical to those parts in the product. A double
insulated product is marked with the words "DOUBLE INSULATION" or
"DOUBLE INSULATED".
The symbol may also be marked on the product.
SERVICING OF DOUBLEINSULATED PRODUCTS
IMPORTANT SAFETY INSTRUCTIONS
II