Owners Manual

TimeFactor User Guide System Menu Tree

maximum value. The Billboard displays the knob value while you’re turning the selected

parameter knob and times out to display the selected [MAX VAL] when the knob is idle.

MIDI CCs send values from 0 to 127. The minimum parameter value will be set when the

MIDI CC sends a 0 and the maximum parameter value will be set when the MIDI CC sends

127. MIDI CC values between 0 and 127 are mapped to the selected parameter range.

The parameters controlled in this mode are system-wide and will apply to all Effects and

Presets.

For example, if Looper was running when you entered System Mode, the Xnob would be

used to select between Play Once and Play Loop. Using RCV CTL you could assign a MIDI

Continuous Controller to Xnob (KB6). CC message values less than 64 will select Play Once

and message values 64 or greater will select Play Loop. If VintageDelay is then loaded, the

Xnob parameter sets the amount of “saturation.” In this case, the MIDI CC value will control

the amount of saturation.

Note: You can set the minimum value to be greater than the maximum value. When you do

so, when the MIDI CC’s sends an increasing value, the parameter value will decrease.

Note: You can assign more than one external controller to any parameter. For example, you

can use MIDI CC10 to vary Delay Time A from 0 ms to 1270 ms with 10 ms resolution and

MIDI CC11 to vary Delay Time A from 0 ms to 127 ms with 1 ms resolution.

Note: While it is possible to assign more than one external controller to any parameter, doing

so is likely to cause confusion and is not recommended. Keep in mind that, if you have

previously assigned a MIDI CC to a control destination, you may want to clear the assignment

before setting up a new assignment. To clear, select the destination (parameter) and select

the source (MIDI CC) as [---].

To Setup the External Control Source

Press the Right Footswitch to select the external control source field for editing. There are two

ways to select an external control source - Manual Select or Learn Mode.

For Manual Select simply turn the Encoder to choose the MIDI Control Source. The choices

are:

BND – MIDI Pitch Bend

CC0 - C99 - MIDI Continuous Controller messages from 0 to 99.

To use the Learn Mode to select the external control source, Press the Right Footswitch again.

“LEARN” is displayed prompting you to send a MIDI message for automatic Control Source

assignment. Press the Right Footswitch again to exit LEARN mode and revert to manual

source selection.

Press the Left and Right Footswitches to toggle between Source and Destination to make as

many assignments as you wish.

The default patch is unassigned [---] for all RCV CTL destinations.

Press the Middle Footswitch once to back-up one level to MIDI menu.

Press the Middle Footswitch twice to go to top level System menu.