Owners Manual

TimeFactor User Guide System Menu Tree
50
To use the Learn Mode to select the external control source, Press the Right Footswitch again.
“LEARN” is displayed prompting you to press an Aux Switch for automatic assignment. Press
the Right Footswitch again to exit LEARN mode and revert to manual source selection.
Press the Left and Right Footswitches to toggle between Source and Destination to make as
many assignments as you wish.
The default patches for Aux Switch control are as follows:
[BYP<>TIP]
[RPT<>RNG]
[TAP<>T+R]
[REC<>TIP]
[PLY<>RNG]
[STP<>T+R]
The other Aux Switch Control destinations ([BK+], [BK-], [P/B], and [KB0]…[KB9]) are
unassigned as indicated by [---].
Note: It is possible to assign the same Aux Switch to multiple destinations. In other words,
you could assign [TIP] to control Bypass AND Tap AND Repeat AND etc. The benefit of having
the same switch control multiple functions can be very useful however, you should keep in
mind that, if you have previously assigned a Switch to a control destination, you may want to
clear the assignment before setting up a new assignment. In fact, the default settings use
this capability to provide both the normal Play functions and the Looper Play functions.
When done, Press the Middle Footswitch to go to top level System menu.
[MIDI] - MIDI Functions
After entering System mode, turn the Encoder to select [MIDI], then press the Encoder to
enter the MIDI functions settings mode.
Turn the Encoder to scroll through the MIDI functions including MIDI Program maps, MIDI
channel, MIDI Data Dumps, etc.
[RCV CH] – Set the MIDI Receive Channel (OFF, OMNI, 1-16)
Press the Encoder to select. Turn Encoder to set the MIDI Receive Channel option. You can
select a MIDI Channel number, turn OFF MIDI receive or choose OMNI to receive on all MIDI
channels.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.
[XMT CH] – Set the MIDI Transmit Channel (1, 2-16)
Press the Encoder to select. Turn Encoder to set the MIDI Transmit Channel.
Press the Middle Footswitch once to back-up one level to MIDI menu.
Press the Middle Footswitch twice to go to top level System menu.